Tools Needed; Reversing The Door Swing - GE Monogram ZDI15 Guía De Uso Y Cuidado

To reverse

TOOLS NEEDED:

putty knife, Phillips screw driver
the door
Parts Supplied:
Parts Identification: (For Reference Only)
IMPORTANT: Before you begin, unplug the
icemaker or disconnect power.
To remove door from hinges:
1. Remove the handle screws and lift off the
2. Remove the hinge pin from the top hinge.
3. Lift the door off of the bottom hinge.
4. Reverse the door endcaps as follows:
•
•
•
5. Set the door aside.
Top Hinge
18
⁄ " wrench,
5
16
Four plug buttons
Hinge Pin
5/16" Hex Head
Hinge Screw
handle (on some models). Keep the parts
together and set them aside.
Place the hinge pin back into the top hinge.
Remove the screws and endcaps from the
door, top and bottom.
Place the top endcap on the bottom of the
opposite side of the door with the long flat
side facing the door front.
Place the bottom endcap on the top of the
opposite side of the door with the long flat
side facing the door front.
Hinge Pin
Hinge Sleeve/
Door Stop
Hex Head Hinge Screw

Reversing the Door Swing

⁄ " wrench, flat
1
To reverse the hinges:
4
1. Using a flat putty knife, remove the plug
buttons from the screw holes opposite of the
door hinges, top and bottom. Set aside.
2. Remove the two screws holding the top
hinge. Turn the hinge upside down so that
the hinge pin points up. Place the hinge on
the opposite side at the bottom of the door.
3. Remove the plastic hinge sleeve from the
"old" bottom hinge and replace it on the
new bottom hinge pin.
4. Remove the bottom hinge. Turn the hinge
upside down so that the hinge pin points
Handle Screw
down. Place the hinge on the opposite side
at the top of the door.
5. Push the plug buttons into the original
Endcap Screw
screw holes.
6. Remove the top hinge pin.
Bottom Hinge
Hinge
Plugs
Icemaker
Top Hinge
Bottom Hinge
Plugs
Hex Head
Hinge Screw
Hinge Sleeve/
Door Stop
Hinge
Hinge Pin