Rubbermaid 5L30 Instrucciones De Armado página 17

b.
Slightly raise front edge of roof enough to allow positioning of
Roof Brace (RB) onto the side walls as shown.
Lower the roof onto the walls and align Roof Brace (RB) into
pocket in Repeat Roof (M).
c.
Ensure Repeat Roof (M) is positioned against the back wall tongues.
From outside the shed, install one Screw (AA) at each corner.
Hold the edge of the roof down firmly at the corners while installing each screw.
Install remaining screws into remaining locations of back walls.
1.
3.
d.
From inside the shed, install four Screws (AA) into the roof at each side wall location.
Note: The screws also have to go through the Roof Brace (RB) at each end to properly secure the roof!
A second person on the outside of the shed should hold down the edge of the roof firmly at each screw location.
2.
AA (4)
M
Helpful Hint: Installation is easier using a magnetic bit or starting
screws with a manual screwdriver to get seated. Pilot holes also may
be drilled using 1/8" bit.
RB
M
M
RB
AA (8)
17