Floor Installation - Rubbermaid 5L30 Instrucciones De Armado

2.0 Floor Installation

A
a.
Using a rubber mallet and
screwdriver, punch out
the screw holes along
the connection edge
of both Repeat
Floors (B)
.
c.
Using a rubber mallet and screwdriver, knock out the
tabs for the door hinge, 2 places on Front Floor (A).
4
B
B
B
B
A
b.
Using a utility knife, cut the long side of each wall slot
tab and then use a rubber mallet and screwdriver to
knock it out:
• 4 places on Front Floor (A)
• 4 places on Repeat Floor (B): middle location
• 8 places on Repeat Floor (B): rear location
1.
2.
d.
Drill pilot hole through top surface of floor, 2 places on Front
Floor (A). CAUTION: Drill through top surface of floor only!
B
B
A
A