Rubbermaid 5L30 Instrucciones De Armado página 19

c.
Make sure middle location Repeat Roof (M) is positioned tightly against the back Repeat Roof (M) section.
Install Roof Pins (FF) in four places. If necessary, use Roof Pin Assembly Tool (GG) to pull the roof down.
1. Insert pin in slot.
FF
d.
From inside the shed, install four Screws (AA) into the roof at each side wall location.
Note: The screws also have to go through the Roof Brace (RB) at each end to properly secure the roof!
A second person on the outside of the shed should hold down the edge of the roof firmly at each screw location.
2. Push all the way through.
GG
Install roof pins four places.
AA (4)
3. Rotate head flush with roof.
M
RB
click
19