Qlima P 126 Instrucciones De Uso página 95

automatically set on 'Medium setting'. Adjusting of the temperature setting
does not have any effect when in dehumidifying mode.
AIR CIRCULATION
In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air entering the unit is not cooled or dehumidified, but is filtered.
When the unit is in this mode, the following functions apply:
• The fan speed can be adjusted by pressing the -button
Maximum setting.
Medium setting.
Lowest setting.
4 When the unit is switched off the most recent setting will be stored in
memory.
5 The timer function allows you to switch the unit on or off at a certain time.
TO SWITCH ON THE UNIT AT A CERTAIN TIME
• Ensure that the unit is set in the required operating mode
• Switch off the unit by pressing the
properly inserted into the wall outlet.
• Press the -button. The light "Timer set" will flash.
• Use the and
• When the set time has expired the unit will switch on.
G
NOTE!
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
The compressor has been set so that it starts functioning three minutes
• When the unit is operating in the required mode press the -button. The
after the (re)start of the air conditioner.
light "Timer set" will flash.
The cooling will switch off when the room temperature is lower than
• Use the and
the set one. Air circulation will however continue to work on the set
• When the set time has expired the unit will switch off.
level. When the room temperature rises above the selected value, the
cooling will work again.
REMOTE CONTROL
a. LCD Screen
b. Power on/off button
c. Timer and thermostat setting buttons
d. Mode button (select A/C, Fan or Dehumidifier)
e. A/C Fan Speed button (High, Medium, Low)
f. Timer ON / OFF button
g. Celsius / Fahrenheit selector
The remote control works in combination with the control panel. Aim the front
end of the remote control at the red window. The maximum operating distance
from the air conditioner is approximately 5 metres. Place 2 pieces of AAA Batteries
before use.
-button. Ensure that the plug is
buttons to set a time between 1 and 24 hours.
buttons to set a time between 1 and 12 hours.
, of .
4
95