Boost Feature; Super Comfort - Cordivari RF Manual De Uso

2. Without programme
On the version without occupancy detector, if the 7 day and daily
programme is not enabled or no orders are being sent by pilot wire, then
your device's factory setting mean that it will operate in non-stop Comfort
mode, 7 days of the week.
• Comfort mode
Non-stop Comfort mode. The device will operate 24 hours a day to
achieve the temprature which has been set (e.g. 19°C). The Comfort
mode temperature level can be set by the user.
• Eco mode
Eco, which means the Comfort Modetemperature minus 3.5°C. This
enables you to lower the temprature without having to reset the Comfort
Mode temperature. Select this mode for short-term absences (between 2
and 24h) or during the night.
• Frost protection mode
This mode enables you to protect your home against the eff ects of cold
weather (frozen, pipes, etc.), by maintaining a minimum temperature of
7*C in it at all times. Select this mode when you will be away from your
home for a long time (more than 5 days)

3.3 Boost feature

Important: the Boost mode can be enabled at any time, whatever the
current operating mode (Auto, Comfort, Eco or Frost protection).
To activate Boost mode, press
will be set at maximum for the time period you request. 60 minutes
display will fl ash by default.
•
Cod. 1910000000274 - nv01
the desired temperature setting
• First press: Boost
Comments:
- If the heating indicator is switched on, the device switches on and heats
the room in addition to the heat emitted by the device.
- At any time, you can modify the Boost duration from 0 to the maximal
authorised duration of the Boost, such as defi ned during the advanced
setting by intervals of 5 minutes by turing the dial. This modifi cation will
be saved and eff ective for the next Boost.
If the ambient temperature reaches the maximal Boost temperature
during the count:
Comments: The device switches off but the Boost mode is always active:
the count is always displayed, the Boost symbol and the heating indicator
fl ash on the display. When the temperature drops under the maximal
authorised temperature, the device will be restarted until the count ends.
• Second press: Boost cancellation
The cursor moves above the previous active mode and the setting
temperatura appears.

3.4 Super Comfort

The blower could be used as an instant additional heating in case of an
inportant diff erence between the ambient temperature and the desired
temperature setting.
The Super Comfort switches on if the diff erence between the ambient
temperature and the setting temperature is higher than 2°C.
The Super Comfort is enabled by default (see chapter "User settings" then
"Super Comfort mode").
Example: The device is in Eco set 17,5°C, you decide to switch in Comfort
mode: the diff erent between 21°C and 17,5°C is 3,5°C, so higher than
2°C. The blower starts up automatically to help the temperature increase
and attain the 21°C desired. The Boost symbol and the heating indicator
appears on the display and the cursor above the selected mode will
fl ash.
- 27 -
English