Day And Daily Programme - Cordivari RF Manual De Uso

occupancy patterns.
• Operating
Upon the fi rst activation of your device, the mode "auto-programme"
is activated by default, in mode Auto. To deactivate and change the
programme,see choice and aff ectation of programmes. The fi rst week
of operation is a learning week during which the device memorizes your
habits and elaborates a programme for the week. It therefore defi nes
a programme built up of periods of Comfort and Eco, independently
for each day of the week. During this learning week, the device will
provisionally function in permanent "Comfort" mode.
Example of display
in Comfort period
Important: To ensure the auto-programming is optimized, please ensure the
presence detection sensor is not obstructed by an external source, refer to
your device's instruction manual.
• Application of the intelligent programme
One week after switching on, the device will apply the new programme for
the next 7 days. Then week after week the device will continue to optimize
the intelligent programme "Auto", adjusting the Comfort and Eco periods to
fi t closely to your lifestyle. When the product is in Frost protection mode
or in standby mode for mode than 24 hours, learning and optimization of
the intelligent programme stops: the device stores the previously recorded
programme from the last week before switching to the Frost protection or
standby mode.
- Example 1: If the product is installed in mid-season or if its installation is
anticipated on the construction site, it can be switched on in standby mode.
When you select the Auto mode, the learning week will start automatically.
The device will be in permanent comfort and will memorize your habits to
aplly the adapted programme the following week.
- Example 2: In the case of control by pilot wire coming from an energy
manager for example, the pilot wire will take precedence over the AUTO
programme which results from the Self-learning algorithm.
3.9.2.

7 day and daily programme

In this mode, you have the option of programming your device, by setting
one of the fi ve programmes on off er each day of the week.
• Access to the programming mode
From Auto, Comfort, Eco or Frost protection mode, press
seconds to enter into the programming mode..
Schematic sequence of programming settings:
→
Setting time
• Setting day and time
In this mode, you can set day and time to programme your device in line
with your needs.
1- From Auto, Comfort, Eco or Frost protection mode, press
seconds.
Cod. 1910000000274 - nv01
Example of display in
Eco period
→
Setting day Programmes choice
The clock symbol appears.
2- Select using
scroll quickly if you hold the
3- The minutes fi gures will fl ash. Select using
.
for 5 4- The cursor above the number 1 (which represents the monday) will fl ash.
Select the day using
for 5
- 29 -
or . The hours fi gures will fl ash. The hours will
or buttons. Save by press
or
or . Save by pressing
English
.
. Save by pressing
.