Installing Flat Panel Display To Wall Plate - PEERLESS SmartMount ST635 Instrucciones De Montaje

Mounting and Removing Flat Panel Display
WARNING
• Always use an assistant or mechanical lifting equip-
ment to safely lift and position the fl at panel display.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display
from the bottom.
3 Tension Adjustment of Ratchet Handle:
tension in adapter brackets (BB & CC) by rotating
ratchet handle. NOTE: If obstruction prevents ratchet
handle from rotating, pull handle out while turning will
allow handle to reposition without tightening. Release
and turn handle to tighten or loosen.
Mounting Display: Ratchet handle must be in the
up or down position or interference will occur while
hooking adapter brackets to wall plate (AA). Slowly
hook adapter brackets (BB & CC) onto wall plate (AA)
and swing display down as shown in fi g. 3.1. Adapter
bracket hooks must fully engage wall plate as shown in
detail 1. Using phillips screw driver or security
driver (FF), turn safety/security screws on adapter
brackets (BB & CC) clockwise till screw tip securely
contacts wall plate as shown in cross section.
Display Adjustment: Display can be adjusted
horizontally by loosening safety/security screws on
adapter brackets (BB & CC) three full turns. Adjust
display as shown in fi gure 3.2. Tighten safety/security
screws on adapter brackets till screw tip securely
contacts wall plate as shown in cross section.
Removing Display: To remove display from mount,
loosen safety screws, swing display away from mount,
and lift display off of mount.
Adjusting the Tilt Angle of the Flat Panel
Display
4
For preset tilt angles use
tilt angle use ratchet handle.
INCRELOK™: The display can be locked into a
pre-set tilt position of -5°, 0°, 5°,
locator hole to fi nd tilt position hole and tilt display
to align holes. Tighten IncreLok™ tilt locking
screws on both adapter brackets to lock tilt as
shown in detail 2.
Ratchet Handle: Loosen ratchet handle (refer to
step 3 for tension adjustment of handle).
pull from top or bottom of display to adjust tilt as
shown in fi gure 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
Adjust
Increlok™ and for custom
10° or 15°. Use
Push or
7 of 30
AA
DETAIL 1
AA
SAFETY/
SECURITY
SCREW
CROSS SECTION
IncreLok™
TILT LOCKING
SCREW
TILT
POSITION
DETAIL 2
HOLES
ISSUED: 02-18-08 SHEET #: 202-9249-6 04-05-11
All other brand and product names are trademarks or registered trademarks of their respective owners.
BB
&
CC
RATCHET
HANDLE
BB
&
CC
LOCATOR
HOLE
RATCHET
HANDLE
fi g 4.1
© 2011, Peerless Industries, Inc. All rights reserved.
Peerless Industries, Inc.
2300 White Oak Circle
www.peerlessmounts.com
fi g 3.1
fi g 3.2
Aurora, Il 60502