Over-Temperature Protection; Residual Heat Warning; Using The Timer - Candy CEHDD30TCT Manual De Instrucciones

Over-Temperature Protection

A temperature sensor equipped can monitor the temperature inside the ceramic
hob. When an excessive temperature is monitored, the ceramic hob will stop
operation automatically.
Over-spillage Protection
Over-spillage protection is a safety protection function. It switch off the hob
automatically within 10s if the water flow to the control panel, while buzzer will
beep 1 second.

Residual Heat Warning

When the hob has been operating for some time, there will be some residual
heat. The letter " H "appears to warn you to keep away from it.
Auto Shutdown
Auto shut down is a safety protection function for your ceramic hob. It shut down
automatically if ever you forget to turn off your cooking. The default working times
for various power levels are shown in the below table:
Power level
Default working timer (hour)

Using the Timer

You can use the timer in two different ways:
• You can use it as a minute minder. In this case, the timer will not turn any
cooking zone off when the set time is up.
• You can set it to turn one cooking zone off or more than one after the set time is
up.
• You can set the timer for up to 99 minutes.
Using the Timer as a Minute Minder
If you are not selecting any cooking zone
1. Make sure the cooktop is turned on.
Note: you can use the minute minder even if you're not selecting any cooking
zones.
2.
Touch timer control, the minder indicator will start
flashing and "30" will show in the timer display.
1 2 3 4
8 8 8 4
EN-11
5 6 7 8
4 4 2 2
9
2