Fitting And Adjusting The Shoulder Strap - Stihl HTA 66 Manual De Instrucciones

English
► Maintain an angle of no more than 45° to the
horizontal.
► Turn the clamp nut (1) a half-rotation
towards .
► Adjust the shaft (2) to the required length.
► Turn the clamp nut (1) in direction as far as it
will go.
► Check that the shaft (2) cannot be shifted any
more ant that the clamp nut (1) is twisted tight
in direction as far as it will go.
The shaft length is properly adjusted if the shaft
(2) cannot be pushed in or pulled out and the
clamping unit is screwed tight, as far as it will go,
in direction of .
11.2 Fitting and Adjusting the Shoul‐
der Strap
► Put on the shoulder strap (1).
► Adjust the shoulder strap (1) so that the cara‐
biner (2) is about a hand's width below your
right hip.
Other approved carrying systems are listed in
this User Manual,
11.3 Holding and Controlling the
Pole Pruner
► Connect the carrying ring (2) to the carabi‐
ner (1).
42
1
2
21.1.
1
2
► Hold the pole pruner with one hand by the
control handle – wrap your thumb around the
control handle.
► Hold the pole pruner firmly with your other
hand by the handle hose - wrap your thumb
around the handle hose.
11.4 Limbing
Cross-cut
1
► Position the stop (1) against the branch.
► With the chain running a full speed, pivot the
guide bar downward against the limb.
► Cut through the limb with the bottom of the
guide bar.
2
► If the limb is under tension: Make the relieving
cut (1) at the compression side and then per‐
form the bucking cut (2) from the tension side.
11 Using the Pole Pruner
1
0458-191-9821-B