Adjusting Pole Pruner For The User; Fitting And Adjusting The Carrying System; Adjusting Length Of Shaft - Stihl HTA 65 Manual De Instrucciones

8 Adjusting Pole Pruner for the User

► If the oil tank still cannot be closed properly: Do not use
your pole pruner and contact a STIHL dealer for
assistance.
The pole pruner is not in a safe condition.
8 Adjusting Pole Pruner for the User
8.1

Fitting and Adjusting the Carrying System

1
2
► Put on the shoulder strap (1) or full harness (3).
► Adjust the shoulder strap (1) or full harness (3) so that the
carabiner (2) is about a hand's width below your right hip.
8.2

Adjusting Length of Shaft

HTA 85
The length of the shaft can be adjusted to suit the height and
reach of the user.
► Switch off the pole pruner, push retaining latch to position
and remove the battery.
0458-766-9921-B
► Open the lever (1) of the quick release clamp (2).
► Adjust shaft (3) to the required length.
► Close the lever (1) of the quick release clamp (2).
3
If the shaft can still be telescoped, the clamping force must
be increased.
2
► Open the lever (1) of the quick release clamp (2) half way.
► Hold the lever (1) of the quick release clamp (2) firmly and
► Close the lever (1) of the quick release clamp (2).
► If the lever (1) of the quick release clamp (2) cannot be
2
180° 1
The shaft (3) is now fixed in position.
2
90°
1
tighten the screw (4) moderately.
closed properly:
► Open the lever (1) of the quick release clamp (2) half
way.
► Loosen the screw (4) slightly.
► Close the lever (1) of the quick release clamp (2) again.
English
3
4
2
57