Troubleshooting - cecotec CONGA ROCKSTAR MICRO 12000 Manual De Instrucciones

Use a soft, damp cloth to clean the product's surface.
Do not immerse the appliance in water or other liquid.
Do not use abrasive scouring pads, powders or cleaners.
Store the device, the charger and the charging base in a cool, dry area.
Cleaning the dust tank and filters
Fig. 7.
Without removing the dust tank from the device, place the dust tank vertically above the
rubbish bin and press the release button shown on the picture. The dust tank will open. Empty
the dirt.
Tap the dust tank lightly to knock off dust and debris.
For a more thorough cleaning, remove the dust tank as indicated on the "Removing the dust
tank" section. Use water and soap if necessary.
Fig. 8.
While the device is switched off, take out the whole set of filters from the dust tank.
Turn the cover anticlockwise and remove the stainless steel filter.
Clean it with a cloth, water and soap, and allow it to dry completely before replacing it.
Turn the high-efficiency filter anticlockwise in order to separate it from the base, clean it with a
cloth, a soft brush or water and soap, and allow it to dry completely in a well ventilated place.
Fig. 9.
Fig. 10.
Fig. 11.
Fig. 12.
Follow these steps in the reverse order in order to assemble it back in place.
Fig. 13.
It is recommended to clean the dust tank after each use.
When the filter accumulates too much dust, it is recommended to clean or replace it.
After long-term use, the accessories must be cleaned to remove any hair or dirt entangled.

7. TROUBLESHOOTING

Problem
Not working
Possible cause
No battery.
Circuit problems.
ENGLISH
Solution
Charge the battery.
Do not disassemble the
product. Contact the Technical
Support Service of Cecotec.
CONGA ROCKSTAR MICRO 12000
35