Using Viewweld To Manage Logged Welding Reports, Print Tags, And Assign Geo-Data - HURNER CNCECO 12002.0 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Type of Error
Temperature high
Low Voltage
High Voltage
Error Changeover
Error Drag Pressure
Error Build-up Pressure
Error Heat Soak
Pressure
Error Joining Pressure
Overheated
Cooling Stopped
Temperature Too Hot
Error Plate Temperature Heating element temperature is out of tolerance; impos-
Emergency Stop
4.6 Using ViewWeld to Manage Logged Welding Reports, Print
Tags, and Assign Geo-data
The View Weld feature offers viewing an abstracted version
of the welding report recorded during the last welding pro-
cess and printing it as a label tag to be affixed to the joint
on the optionally available tag printer. The View Weld ab-
stract shows the report number, the date and time of the
welding and the welding parameters along with an evalua-
tion of the quality of the joint/welding operation (see Dis-
play 34).
Version October 2021
The heating element temperature will be reduced
automatically.
The input voltage to the hydraulic and control unit is
< 320 V; the welding process is likely flawed, and repeating
it is recommended.
The input voltage to the hydraulic and control unit is
> 485 V; the welding process is likely flawed, and repeating
it is recommended.
It took too long to retract the heating element and bring
the pipes to joining; welding will have to be repeated.
Impossible to determine the drag pressure; maybe pipes
will have to be clamped once again.
The computed maximum pressure for the welding, which
will be applied during bead build-up and jointing, is too
high; impossible to start welding; maybe pipes will have to
be clamped once again.
The heat-soaking pressure is too high and could not be
re-adjusted.
The joining pressure is too high or too low and , could not
be re-adjusted.
The temperature of the hydraulic unit is too high. The next
welding may result in overheating of the unit, which is
why the welding operation is possible only after a period
of letting the hydraulic unit cool.
Operator has stopped the cooling time by pressing the
STOP/REST key.
The temperature of the hydraulic and control unit is
> 100 °C and it has switches itself off for safety reasons; the
welding process must be repeated.
sible to re-adjust the temperature; if no heating element
failure can be found, maybe the ambient temperature was
too low.
The welder has switched the machine off using the
Emergency Stop switch. If this was done because of a
malfunction of the machine, it must not be turned on
again, unless it is beyond doubt that it works properly.
HÜRNER CNC ECO 1200 2.0 User's Manual
Description
0015 24.02.13 09:33
HST 315
No Error
Display 34
EN
29