Publicidad
Idiomas disponibles
Idiomas disponibles
Load your bike's forks.
Attach hex key
but do not
Release a strap end
tighten.
by pressing the red
button.
Rest the rear wheel
into the tray.
TEST THE STABILITY
OF THE
INSTALLATION BY
TUGGING ON
FORK LEG.
All manuals and user guides at all-guides.com
Set the bicycle
forks vertically
onto the skewer.
Prevent damage to
your forks!
ROUND BARS:
Rotate wheel tray to
accommodate bike wheel.
Tighten the hex key.
If tray can move on the bar,
tighten the hex key.
If forks move out of the
If pod
skewer —
can rotate —
Open lever and tighten
Remove the
the nut slightly. You
skewer and pod
may need to loosen or
cover, and tighten
tighten the nut so that
the screws.
lever closes firmly
Always replace
with resistance.
the pod cover.
With lever open, tighten
the nut until the lever
closes with FIRM
resistance.
TEST YOUR INSTALLATION! If forks can move in the mount,
open the lever and tighten the nut again.
SQUARE BARS:
You may need to reposition
the bolt as in Step 9 to angle
the tray.
Tighten the hex key.
If the wheel is loose in the tray —
Pull down on the strap ends.
(Some bike wheels may be too
narrow to allow a tight fit. The
bike is still secure.)
Tray can rotate on the bar to
adjust to wheel. After adjusting,
tighten the hex key.
Your bike's forks are secure
ONLY after the lever
closes with solid
resistance.
SECURE THE
REAR WHEEL.
Insert strap end
behind red
button.
Pull the strap
tightly against
the wheel rim.
Ride Safe!
Publicidad
