Dreame D9 Manual Del Usuario página 10

Preparation
1. Remove the protective film
Remove the protective films on the side of collision buffer and charging dock.
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
8
3. Place the charging dock on the level ground against wall
and connect to a power outlet
Note:
•
Make sure there is a distance of 0.5 meters or more on either side of the charging dock, and
more than 1.5 meters in front of it.
•
Tidy up any loose cord which could accidentally move or unplug the charging dock.
•
To ensure you can well connect to the robot with your phone, make sure the robot and
charging dock are in the range of Wi-Fi.
•
Do not place the charging dock in an area with direct sunlight or where other objects could
block its signaling area, as this may hinder the robot from returning to the charging dock.
4. Place the robot onto the charging dock to recharge. The
robot will turn on automatically and charge
Battery Level Indicator
•
White: Battery level is more than 15%
•
Orange: Battery level is less than 15%
Note:
•
Fully charge before first use.
•
Don't install the mopping module while charging. Ensure the charging is in a safe
environment to prevent floor damage caused by wet dishcloth.
>0.5m
>0.5m
>1.5m