Start Up Instructions - Garland GAS 700 MG Manual De Instrucciones

English

6. START UP INSTRUCTIONS

6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
• Machine.
• Flexible tube.
• The accelerator for the straight tube.
• Straight tube.
• The air outlet nozzle.
• Tools.
• Instruction manual.
Carefully remove all items from the box and make
sure that all listed items are present. Carefully inspect
the product to ensure that there are no damaged
elements.
If you find any damaged or missing parts, do not
use the machine until the defect has been repaired
or all the missing pieces replaced. Using the machine
without all of its parts or with defective parts can
cause severe personal injury.
6.2. ASSEMBLY
WARNING! To connect blowing pipes you must
insert tube in a way that will fit perfectly until it
reaches the bottom of the slot (1) and turn it tothe end
of the slot (2).
2
Installation of the tubes:
-Attach the straight tube with the throttle lever (3) to
the flexible hose (2) and all of this to the curved tube
(1) with the hose clamp.
-Attach the straight tube (4) to the tube from the
throttle (3) and to this attach the (5) air outlet nozzle.
6.3. MIX OF FUEL AND OIL
Use unleaded gasoline 95 octane and 100% synthetic
two stroke oil.
Do not use fuel that has been stored for longer than
2 months. A fuel that has been stored for too long will
cause the starting of the machine to be more difficult
and an unsatisfactory engine performance. If the fuel
has been in the tank for over two months, remove it
from the machine and replace it with one in perfect
condition.
1
REFUELING THE MACHINE:
1. Choose a suitable area to perform this operation.
2. Shake the container that contains the already
28/112
Engine fuel: mix synthetic oil and
gasoline (gasoline 40: oil 1 = 2.5%).
Mix gasoline and oil in a CE-approved
container.
prepared mixture of gasoline and oil.