Mounting; Electrical Installation - SICK GTE2F-P5111 Manual De Instrucciones

4
OPERATING AND STATUS INDICATORS
en
5

Mounting

6

Electrical installation

6 O P E R A T I N G I N S T R U C T I O N | GTE2 Flat
1
2
Figure 1: Dimensional drawing
LED indicator green: supply voltage active
1
LED indicator yellow: status of received light beam
2
Mount the sensor using a suitable mounting bracket (see the SICK range of accesso‐
ries).
Note the sensor's maximum permissible tightening torque of 0.1 Nm.
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Plug connection: note pin assignment: when the lid is open, the male connector
can be swiveled horizontally and vertically.
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanation of the connection diagram (Tables pin assignment):
Q = switching outputs
n. c. = not connected
DC: 10 ... 30 V DC
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
8025415.1C13/28.06.2021 | SICK
Subject to change without notice