Trouble Shooting - Kyocera TJEP KA-1 Instrucciones De Funcionamiento Y Seguridad

Trouble shooting

Status
The tip of the fastener cannot be used to locate
the hole in the metal connector plate
The tool is leaking air
The tool is blank-firing
No feed of fasteners
Lack of power
Fasteners jam in the tool
For failure other than above situations, please stop using the tool and contact your local dealer for service.
176
Action
• Fastener slid into the wrong magazine groove
· Choose correct groove (40, 50 or 60 mm)
• Loose nose screws
· Tighten screws and recheck
• Loose cap screws
· Tighten screws and recheck
• Damaged seal, gasket or O-rings
· Replace seal, gasket or O-rings
• Dirt in nose (A)
· Clean nose
• Dirty/empty magazine (E)
· Clean magazine
• Air restriction/inadequate air flow
· Check hose and compressor
• Lack of lubrication
· Use TJEP lubricator
• Fasteners too short or wrong size for the tool
· Use recommended TJEP fasteners only
• Bent fasteners
· Do not use
• Low air pressure
· Check hose and compressor
• Lack of lubrication (D)
· Use TJEP lubricator
• Pusher (C) has been released too roughly and thereby damaged the
fastener collation material.
· Always release the pusher gently
• Fastener slid into the wrong magazine groove
· Choose correct groove (40, 50 or 60 mm)
• Bent fasteners
· Do not use
• Loose magazine, nose screws
· Tighten all screws and recheck
• Fastener hit metal connector plate
· Make sure to place the point of fastener into the hole of the metal
connector plate.