Functional Description - Makita DCL180 Manual De Instrucciones

6. Do not store the tool and battery
cartridge in locations where the
temperature may reach or exceed
50 ﾟ C (122 ﾟ F).
7. Do not incinerate
cartridge even if it is severely
damaged or is completely worn out.
The battery cartridge can explode in
a fire.
8. Be careful not to drop or strike
battery.
9. Do not use a damaged battery.
10. Follow your
relating to disposal of battery.
SAVE THESE
INSTRUCTIONS.
CAUTION: Only use genuine Makita
batteries.
Use of non-genuine Makita batteries, or
batteries that have been altered, may result
in the battery bursting causing fires,
personal injury and damage. It will also void
the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before
completely discharged.
Always stop tool operation and
charge the battery cartridge when
you notice less tool power.
2. Never recharge a fully charged
battery cartridge.
Overcharging shortens the battery
service life.
3. Charge the battery cartridge with
room temperature at 10 ﾟ C - 40 ﾟ C
(50 ﾟ F - 104 ﾟ F). Let a hot battery
cartridge cool
charging it.
4. Charge the battery cartridge if you
do not use it for a long period (more
than six months).
All manuals and user guides at all-guides.com
the battery
local regulations
down before
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before adjusting or checking function
on the tool.
Take care not to trap finger(s) between
•
cleaner and battery as shown in
diagram when loading battery.Trapping
finger(s) may cause injury.
010055
Installing or removing battery
cartridge
2
3
012130
Always switch off the tool before
•
installing or removing of the battery
cartridge.
To remove the battery cartridge, slide it
•
from the tool while sliding the button on
the front of the cartridge.
To install the battery cartridge, align the
•
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Always insert it all the way until it
locks in place with a little click. If you
can see the red indicator on the upper
side of the button, it is not locked
4
1. Red indicator
1
2. Battery cartridge
3. Button