Makita DCL180 Manual De Instrucciones página 5

completely. Install it fully until the red
indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing
injury to you or someone around you.
Do not use force when installing the
•
battery cartridge. If the cartridge does
not slide in easily, it is not being
inserted correctly.
Battery protection system
(Lithium-ion battery with star
marking)
1
012128
Lithium-ion batteries with a star marking are
equipped with a protection system. This
system automatically cuts off power to the
tool to extend battery life.
The tool will automatically stop during
operation if the tool and/or battery are
placed under one
conditions:
Overloaded:
•
The tool is operated in a manner
that causes
abnormally high current.
In this situation, release the trigger
switch on the tool and stop the
application that caused the tool to
become overloaded. Then pull the
trigger switch again to restart.
If the tool does not start, the battery
is overheated. In this situation, let
the battery cool before pulling the
trigger switch again.
Low battery voltage:
•
The remaining battery capacity is
too low and the tool will not operate.
In this situation, remove
recharge the battery.
All manuals and user guides at all-guides.com
1. Star marking
of the following
it to draw an
and
5
Indicating the remaining battery
capacity
(Only for battery cartridges with "B" at the
end of the model number.)
1
2
015676
Press the check button on the battery cartridge
to indicate the remaining battery capacity. The
indicator lamps light up for few seconds.
Indicator lamps
Lighted Off
015658
NOTE:
Depending on the conditions of use and
•
the ambient temperature, the indication
may differ slightly from the actual capacity.
Switch action
1
009986
1. Indicator lamps
2. CHECK button
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1. Switch trigger