Description - Hilti DX 36 Manual De Instrucciones

3 Description

3.1 Use of the product as directed
The tool is designed for professional use in fastening applications where nails, threaded studs and composite fasteners
are driven into concrete, steel and sand-lime block masonry.
The tool is for hand-held use only.
Modification of the tool is not permissible.
The tool may not be used in an explosive or flammable atmosphere unless it has been approved for use under these
conditions.
To avoid the risk of injury use only genuine Hilti fasteners, cartridges, accessories and spare parts or those of
equivalent quality.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
The tool may be operated, serviced and repaired only by trained personnel. This personnel must be informed of any
special hazards that may be encountered.
As with all powder-actuated fastening tools, the tool, cartridges and fasteners form a technical unit. This means that
trouble-free fastening with this system can be assured only if the Hilti fasteners and cartridges specially manufactured
for it, or products of equivalent quality, are used. The fastening and application recommendations given by Hilti apply
only when these conditions are observed.
The tool features a 5-way safety system for the safety of the user and all bystanders.
3.2 Piston principle
The energy from the propellant charge is transferred to a piston, the accelerated mass of which drives the fastener into
the base material. Due to use of this piston principle, the tool is classified as a "low velocity tool". As approximately
95% of the kinetic energy is absorbed by the piston, the fastener is driven into the base material in a controlled fashion
at much reduced velocity (less than 100 m/s). The driving process ends when the piston is stopped at the end of its
travel. This makes dangerous through-shots virtually impossible when the tool is used correctly.
3.3 Drop-firing safety device
The drop-firing safety device is the result of coupling the firing mechanism with the cocking movement. This prevents
the tool from firing when dropped onto a hard surface, no matter at which angle the impact occurs.
3.4 Trigger safety device
The trigger safety device prevents the tool firing when only the trigger is pulled. The tool must be pressed against a
firm surface before a fastener can be released.
3.5 Contact pressure safety device
The tool can be fired only when pressed fully against a firm surface with a force of at least 50 N.
3.6 Unintentional firing safety device
The tool is also equipped with an unintentional firing safety device. This prevents the tool from firing if the trigger is first
pulled and the tool then pressed against the work surface. The tool can be fired only when it is first pressed correctly
against the work surface and the trigger subsequently pulled.
3.7 Range of fasteners available for various applications
Fasteners
Ordering designation
X-U
X-C
X-S
X-CT
Application
High-strength nail for fastening on high-
strength steel and concrete in a wide range
of applications
Standard nail for fastening on concrete
Standard nail for efficient fastening on steel
Easily removable nail for fastening form-
work temporarily on concrete
en
21