Makita CL072D Manual De Instrucciones página 6

Aspiradora inalámbrica
Ocultar thumbs Ver también para CL072D:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery power lamp
1
► 1. Battery power lamp
When the remaining battery capacity gets low, the
battery power lamp blinks.
When the remaining battery capacity gets much
lower, the tool stops during operation and the bat-
tery power lamp lights up for about ten seconds.
At this time, remove the battery cartridge from the
tool and charge it .
NOTE:
The time at which the battery power lamp start
blinking or lighting up depends on the tempera-
ture at work place and the battery cartridge
conditions.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes too full, or
the suction force weakens.
Be sure to empty out the dust inside the cleaner
itself. Failure to do so may cause the sponge
filter to be clogged or the motor to be damaged.
Never throw away the dust stopper because it
should be used whenever either the dust bag or
the paper pack is used.
2
► 1. Front cover 2. Button
1.
Push the button to open the front cover. Opening
it until a click is heard allows a positive stop at that
position.
► 1. Front cover 2. Front cover joint
NOTE:
The cleaner is constructed in such a way that
the front cover comes off when trying to force
the front cover open at the angle of more than
90°. If the front cover comes off, insert it into the
front cover joint in place.
CAUTION:
When closing the front cover, be careful not to
pinch your fingers.
1
► 1. Dust stopper
6 ENGLISH
1
1
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cl102d

Tabla de contenido