Publicidad
Idiomas disponibles
Idiomas disponibles
is automatically started. This takes typically between 3-5 minutes
in good conditions.
Note:
Daily DCF reception is done at 02:00 and 03:00 every day. If the
reception at 03:00 is not successful, then at 04:00 and 05:00 and 06:00
there are other tries, until one is successful. If the reception at 06:00 is
still not successful, then the next try takes place at 02:00 next day.
If reception is successful, the received time will override the manually
set time. (Please refer also to notes on "DCF-77 Radio Controlled
Time" and "Manual Time Setting")
How to install and replace the batteries in the weather station:
The weather station uses 2 x AAA, IEC LR3, 1.5V batteries. When
batteries will need to be replaced, the low battery icon will appear on
the LCD. To install and replace the batteries, please follow the steps
below:
1.
Lift up the battery compartment cover.
2.
Insert batteries observing the correct polarity (see marking).
3.
Replace compartment cover.
How to install and replace the batteries in the temperature sensor:
The temperature sensor uses 2 x AA, IEC LR6, 1.5V battery. To install
and replace the batteries, please follow the steps below:
1.
Remove the battery compartment cover at the back of the sensor.
2.
Insert the batteries, observing the correct polarity (see marking).
3.
Replace the battery compartment cover on the unit.
Note:
In the event of changing batteries in any of the units, all units need to be
reset by following the setting up procedures. This is because a security
code is assigned by the sensor at start-up and this code must be
received and stored by the weather station in the first 3 minutes of
power being supplied to it.
EN3
Publicidad
