Remote Control - Sony AIWA CSD-MP100 Instrucciones De Manejo

Setting up
You can use the AC power or batteries as a power
source.
Using on batteries
Open the lid of the battery compartment at the bottom
of the player, and insert six size D (R20) batteries (not
supplied) correctly. Then close the lid.
To use the player on batteries, disconnect the AC
power cord from the player.
If the batteries are not correctly inserted,
"BATTERY" and "ERROR" appear on the display and
the player do not accept any operation. In this case,
check them and insert them correctly.
Replacing batteries
When the batteries become weak, "LO-BATT" appears
on the display. Replace all the batteries with new ones.
If not replacing them, "BATTERY" and "ERROR" will
appear after a while and the player will not accept any
operation.
Note
Before you replace the batteries, be sure to take out the
CD from the player.
4
ENGLISH
All manuals and user guides at all-guides.com
Using on the AC power (house current)
Connect the supplied AC power cord.
supplied AC power cord
Insert one end of the supplied AC power code to the AC
IN socket located at the rear of the player, and the other
end to the wall outlet.
CAUTION
Use only the supplied AC power code. Use with other
codes may result in the risk of fire.

Remote control

Preparing the remote
Insert two size AA (R6) batteries (not supplied).
To use the buttons on the remote
In principle, buttons on the remote and the player with
identical indications have the same functions.
Replacing batteries
With normal use, the batteries should last for about 6
months. When the remote no longer operates the
player, replace all the batteries with new ones.
1 to the AC IN socket
2 to an AC outlet
(AC 120 V, 60 Hz)