Brita Redi-Twist Instrucciones De Instalación página 10

auxiliary faucet installation
Install Redi-Twist
and Test for Leaks
1/4 turn
• Hold the Redi-Twist™ filter with the
label facing you.
• Insert filter up into the system head
until the two nozzles seat into the ports.
• Turn the Redi-Twist™ filter from left
to right (as you face it) until it stops.
• Turn on the cold water shut-off valve.
• Turn on the new faucet. Allow
the water to run for approximately 10
minutes.
• Check for any leaks.
• If system is leaking, turn off cold
water shut-off valve and refer to
troubleshooting guide.
10
Filter
™
Step 4
Align Arro w
auxiliary faucet installation
Filter Replacement
(every 6 months)
1/4 turn
For FREE Filter Replacement
Reminder, go to
www.protectplus.com
Note: Place paper towels or rag under the filter
system to catch any water drips.
• Turn the Redi-Twist™ filter right to
left (as you face it) until it releases.
Remove and discard used Redi-
Twist™ filter.
• See Step 4 for inserting new filter.
• Changing water filter on a regular
basis ensures optimum performance
of the water filtration system.
• Note date filter is installed on
cartridge tank label.