Setting Up; Choosing The Power Sources; Replacing Batteries - Sony AIWA CSD-A500 Manual De Instrucciones

Setting Up

Choosing the power sources

You can use the AC power or batteries as a power source.
1
Connecting the mains lead
Insert one end of the supplied mains
lead to the AC IN socket located at the
rear of the player, and the other end to
the mains.
Changing the MW tuning interval
The MW tuning interval is preset to
9 kHz at the factory.
If you need to change the MW tuning
interval to 10 kHz step, do the following:
1 Set the function switch to RADIO.
2 While holding down xENTER, press and
hold PRESET for about 2 seconds to
change the setting to 10 kHz step.
To set the tuning interval back to 9 kHz step,
follow the same procedure again.
After changing the tuning interval, you need
to reset your preset radio stations.
3 Battery compartment
AC IN
1 to the mains
2
Inserting batteries into the remote
Insert two R03 (size AAA) batteries
(not supplied).

Replacing batteries

With normal use, the batteries should last for
about six months. When the remote no
longer operates the player, replace all the
batteries with new ones.
continued
GB
21