Troubleshooting - Sony AIWA CSD-A500 Manual De Instrucciones

Troubleshooting

General
The power is not on.
• Connect the mains lead to the AC IN socket
and a wall outlet securely.
• Make sure the batteries are inserted correctly.
• Replace all the batteries with new ones if
they are weak.
• You cannot turn on the player with the
remote when you operate the player on
batteries.
The power is not on, and "Er" and "bAtt"
are displayed.
• Make sure the batteries are inserted correctly.
The OPR/BATT indicator dims or the
player stops operating.
• The batteries are weak.
c Replace all the batteries with new ones.
The clock display flashes.
• This is caused by a power interruption.
c Reset the clock.
There is no audio.
• Unplug the headphones when listening
through the speakers.
Unusual sound is heard.
The sound is noisy, weak or of poor
quality.
• Replace all the batteries with new ones if
they are weak.
Noise is heard.
• Someone is using a portable telephone or
other equipment that emits radio waves near
the player.
c Move the portable telephone, etc., away
from the player.
GB
26
CD player
The CD does not play or "noCd" is
displayed even when a CD is in place.
• Place the CD with the label surface up.
• Clean the CD.
• Take out the CD and leave the CD
compartment open for about an hour to dry
moisture condensation.
• The CD-R/CD-RW is blank.
• The CD-R/CD-RW was not finalized.
Finalize the CD-R/CD-RW with the
recording device.
• There is a problem with the quality of the
CD-R/CD-RW, recording device, or
application software.
• Replace all the batteries with new ones if
they are weak.
The sound drops out.
Noise is heard.
• Reduce the volume.
• Clean the CD, or replace the CD if it is badly
damaged.
• Place the player in a location free from
vibration.
• Clean the lens with a commercially available
blower.
• The sound may drop out or noise may be
heard when using poor quality CD-Rs/
CD-RWs or if there is a problem with the
recording device or application software.
You cannot open/close the lid of the CD
compartment.
• Place the player on a level surface.
Radio
The audio is weak or has poor quality.
• Replace all the batteries with new ones if
they are weak.
• Move the player away from the TV.
• If you are using the remote while listening to
an MW/LW programme, noise may be heard.
This is unavoidable.
The picture of your TV becomes unstable.
• If you are listening to an FM programme near
the TV with an indoor aerial, move the player
away from the TV.