Card Remote Control; Names Of Parts; Replacing The Battery - Sony AIWA CDC-R937 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
CARD REMOTE
CONTROL

Names of parts

1 TUNER button
2 CD button
3 rAMS (Auto music sensor) button
4 tAMS (Auto music sensor) button
5 PS (preset) button
6 TUNING UP/DOWN buttons
7 VOLUME +/- buttons
Preparations
A lithium battery is installed in the remote control at the
factory.
Before you use the remote control, be sure to remove
the insulating sheet by simply pulling it out.
Remote control (back)
Insulating sheet
9
ENGLISH

Replacing the battery

1
Insert the tip of a pointed object A into the hole B
and pull out the battery holder to remove the lithium
battery (CR2025).
Remote control (back)
Battery holder
2
Install a new lithium battery (CR2025) with the )
side facing up in the battery holder.
3
Push the battery holder into the unit until it clicks.
Note
When the infrared receptor on the main unit is exposed
to direct sunlight, it may not respond to signals from the
remote control.
CAUTIONS
• Lithium battery (CR2025) for the remote control
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Discard used batteries according to the manufacturer's
instruction.
• Keep the lithium battery out of the reach of children. If
swallowed, consult a doctor immediately.
• To prevent a short circuit, never pinch the battery with
pliers, etc.

Publicidad

Tabla de contenido
loading

Tabla de contenido