Information On This Document; Target Group; Intended Use; Quick Reference Guide - SMA SUNNY TRIPOWER CORE1 Instrucciones Breves

SMA Solar Technology AG
1 Information on this Document
1.1 Validity
This document is valid for device type "STP 50-40" (Sunny Tripower CORE1).
1.2 Structure
This document is divided into a language-specific and a language-neutral section.
The language-specific section contains general and safety-relevant information on the product,
which is listed in various languages consecutively. The language-specific section is identified by
registers in the page margin.
The language-neutral section describes the steps necessary for installing and commissioning the
product in graphic form. The language-neutral section follows the language-specific section and is
identified by the gray page margin. Perform the actions illustrated graphically in the language-
neutral section in the specified order and observe all information.
The latest version of this document and the comprehensive manual for installation, commissioning,
configuration and decommissioning are to be found in PDF format at www.SMA-Solar.com.
1.3

Target Group

The tasks described in this document must only be performed by qualified persons. Qualified
persons must have the following skills:
• Knowledge of how an inverter works and is operated
• Training in how to deal with the dangers and risks associated with installing and using
electrical devices and installations
• Training in the installation and commissioning of electrical devices and installations
• Knowledge of the applicable standards and directives
• Knowledge of and compliance with this document and all safety information
2 Safety
2.1

Intended Use

The Sunny Tripower is a transformerless PV inverter, with 6 MPP trackers, that converts the direct
current of the PV array to grid-compliant, three-phase current and feeds it into the utility grid.
The product is suitable for indoor and outdoor use.
The product must only be operated with PV arrays of protection class II in accordance with
IEC 61730, application class A. The PV modules must be compatible with this product.
The product must only be operated with PV modules and cables that have been recommended and
sold by the distributor. Do not connect any energy sources other than PV modules to the product.
The product is not equipped with a transformer and therefore has no galvanic isolation. The
product must not be operated with PV modules whose outputs are grounded. This can cause the
product to be destroyed. The product may be operated with PV modules whose frame is grounded.

Quick Reference Guide

1 Information on this Document
STP50-40-IS-xx-10 3