Siemens RVL482 Instrucciones De Montaje página 37

7. Underfloor and ceiling heating systems: The limit thermostat must be set to the correct
8. Switch on power. The display must show something (e.g. the time of day). If not, the reason
General information about operation
•
•
•
•
Building Technologies
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk 0844 556 1818
value. During the functional test, the flow temperature may not exceed the maximum per-
missible level (usually 55 °C). If it does, proceed immediately as follows:
– Either close the valve manually, or
– Switch off the pump, or
– Close the pump isolating valve
may be one of the following:
– No mains voltage present
– Main fuse defect
– Main switch not set to ON
Setting elements:
– Heating curve
– Setting knob
– Display; one operating line is assigned to each setting
– Buttons for selecting and readjusting the values:
Selecting the next operating line below
Selecting the next operating line above
Decreasing the displayed value
Increasing the displayed value
Adopting a setting value:
The setting value is adopted by selecting the next operating line (or: Press Info button or one
of the operating mode buttons)
Entering --.- or --:-- :
Press or until the required display appears
Block jump function:
To select a single operating line quickly, two button combinations can be used:
Press and for selecting the next line block above
Press and for selecting the next line block below
74 319 0619 0 a 17.04.2008 37/288
en