Freezer Operation - Jocel JCH-100 Manual De Instrucciones

1. The interior is dry and air can circulate freely at the rear.
2. Clean the interior as recommended under "CLEANING AND CARE".
3. Insert the plug into the wall socket and switch on the electricity supply then the Red light is
on.
4. You will hear a noise as the compressor starts up. The liquid and gases sealed within the
refrigeration system may also give rise to noise, whether the compressor is running or not
which is quite normal.
5. If you going to store already frozen food open the freezer lid and check that the freezer has
reached the correct temperature. Then you can put in your already frozen food.
6. Do not load the appliance immediately after it is switched on. Wait until the correct storage
temperature has been reached.
Important Notes:
 If there is a power failure do not open the lid. Frozen food should not be affected if the
failure lasts for less than 20 hours. If the failure is longer, then the food should be checked
and eaten immediately or cooked and then refrozen.
 If you find that the lid of the chest freezer is difficult to open just after you have closed it,
don't worry. This is due to the pressure difference which will equalize and allow the lid to
be opened normally after a few minutes.

FREEZER OPERATION

The inside temperature of freezer is regulated by thermostat adjustment knob.
The "1,2,3,4,5,6" marks on the knob do not represent the exact temperature, but show that the
smaller number represent the higher the temperature, conversely, the bigger number, the
lower the temperature.
Temperature adjustment
Turn the thermostat to set the temperature.
 Position 1: cooling mode (temperature from 5ºC)
 Position 2 to 4: soft freeze mode (temperature from -12 to -18ºC)
 Position 4 to 7: freezing mode (temperature from -18ºC to -24ºC)
 Position 7: quick freeze mode (temperature below -24ºC)
30