Removing The Battery - Würth master 0700 624 Serie Manual Del Usuario

All manuals and user guides at all-guides.com
OBJ_BUCH-1468-001.book Page 16 Wednesday, July 20, 2011 11:10 AM
Declaration of Conformity
We declare under our sole responsibility that the
product described under "Tool Specifications" is in
conformity with the following standards or standardi-
zation documents: EN 60745 according to the provi-
sions of the directives 2004/108/EC, 2006/42/EC.
Technical file at:
Adolf Würth GmbH & Co. KG, Abt. PFW
74650 Künzelsau
T. Klenk A. Kräutle
General Manager General Manager
Künzelsau: 01.04.2011
Battery Charging
Note: The battery is supplied partially charged. To
ensure full capacity of the battery, completely charge
the battery in the battery charger before using your
power tool for the first time.
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The lithium-ion battery is protected against deep dis-
charging by the "Electronic Cell Protection (ECP)".
When the battery is empty, the machine is switched off
by means of a protective circuit: The inserted tool no
longer rotates.
Do not continue to press the
WARNING
On/Off switch after the
machine has been automatically switched off.
The battery can be damaged.
The battery is equipped with a NTC temperature con-
trol which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery
service life is achieved in this manner.
Observe the notes for disposal.

Removing the Battery

The battery 5 is equipped with two locking levels that
should prevent the battery from falling out when
pushing the battery unlocking button 6 unintention-
ally. As long as the battery is inserted in the power
tool, it is held in position by means of a spring.
To remove the battery 5, press the unlocking button 6
and pull out the battery toward the front. Do not
exert any force.
Changing the Tool (see figure A)
❏ Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion. Unintentional actuation of the On/Off switch
can lead to injuries.
ASS 14-1/4":
Inserting
Pull the locking sleeve 2 forward, push the insert tool
to the stop into the tool holder 1 and release the lock-
ing sleeve 2 to lock the insert tool.
Use only screwdriver bits with ball catch 11
(DIN 3126-E6.3). Other screwdriver bits 13 can be
used with a universal bit holder with ball catch 12.
Removing
Pull the locking sleeve 2 forward and remove the
insert tool.
ASS 18-1/2":
❏ When working with an application tool, pay
attention that the application tool is firmly
seated on the tool holder. When the applica-
tion tool is not firmly connected with the tool
holder, it can come loose again and not be con-
trolled.
Slide the application tool onto the square drive of the
tool holder 1.
Method of Operation
The tool holder 1 with the tool is driven by an electric
motor via a gear and impact mechanism.
The working procedure is divided into two phases:
Screwing in and tightening (impact mechanism in
action).
16