Uline H-9234 Instrucciones De Montaje página 5

13. Raise other side of tent and attach remaining legs.
(See Figure 19)
Figure 19
14. Fasten the rest of the alligator straps around eave
poles (EV) by tugging on the excess strap to keep
the material taut and pull straps firmly. Slide excess
strap through metal slide on the alligator clip.
(See Figure 20)
Pull to tighten.
CAUTION! Yanking on straps will cause undue
wear and tear as well as wrinkling of tent top
fabric.
IF USING STAKES (H-9234)
1. Place stakes 5' out from each leg. Drive stakes into
the ground until 6" or less of the stake shows.
(See Figure 21)
Figure 21
PAGE 5 OF 24
ASSEMBLY CONTINUED
2. Attach ratchet straps to the stakes loosely.
(See Figure 22)
a. Attach ratchet buckle with loop strap to stakes
b. Pull slipknot tight over stake.
c. Take loop strap attached to tent and pull it
Figure 20
3. Tighten ratchet straps by holding strap and pulling
all slack through ratchet reel. Pull all slack through
ratchet reel, holding strap with one hand and
cranking ratchet handle with the other.
4. Roll excess ratchet straps
and secure into the ratchet
buckle. (See Figure 23)
by turning the 6" loop at the end of the ratchet
inside out and pulling strap through the loop.
through reel bars slot of ratchet.
NOTE: Keep ratchet buckle handle facing up
at all times.
Figure 22
b
a c
Figure 23
Completed Assembly
with Stakes
0721 IH-9234