Maintenance And Cleaning; Cleaning - Deltafox DG-ECS 2240 Traducción Del Manual De Instrucciones Origina

1. Log is lying on the ground:
Saw through the log completely
from above and ensure at the
end of the cut not to contact the
ground.
If you can turn the tree trunk,
saw two-thirds of the way
through it. Then turn the trunk
around and saw the rest of the
way through from above.
2. Log is supported at one end:
Start sawing from the bottom
and work your way up (with the
upper edge of the bar) a third of
the way into the diameter of the
trunk to prevent splitting. Then
saw from the top downwards
with the lower edge of the bar
towards the first cut to prevent
the bar from becoming jammed
in the wood.
3. Log is supported at both
ends:
Start from the top and work
down (with the lower edge of the
bar) to a third of the diameter of
the trunk. Then saw from under-
neath with the upper edge of the
bar until the two cuts meet.
4. Sawing on a sawhorse:
Hold the electric chainsaw
steady with both hands, keep-
ing the saw in front of you
while sawing. Once the saw is
through the wood, guide the
machine passed you on the
right (1). Hold your left arm as
straight as you can (2). Watch
out for the falling trunk. Position
yourself to prevent any danger
from the separated trunk. Watch
your feet. The trunk may cause
injuries when falling. Keep your
balance (3).
Maintenance and

cleaning

Basically, carry out maintenance
and cleaning works with switched-
off motor and power plug re-
moved. Danger of injury!
Leave any maintenance and ser-
vicing work not covered by this
manual to our Service-Center. Use
only original spare parts.
Allow the machine to cool down
before all maintenance and clean-
ing works. Danger of burn injuries!
Cleaning
• Clean the machine thoroughly after
every use. In this way, you extend the
life of the machine and avoid accidents.
• Keep the gripping handles free of
petrol, oil or grease. Clean the grip-
ping handles, where appropriate, with
a moist cloth soaked in soap. Use no
solvents or petrol for cleaning!
• Clean the saw chain after every use. Use
a paint brush or wipe for that. Do not use
any liquids to clean the chain. After clean-
ing, oil the chain lightly with chain oil.
• When cleaning, also remove the chain
wheel cover (
can be cleaned as well.
• Clean the chain bar (Guide) (
• Clean the ventilation slots and the
surfaces of the machine with a paint
brush, whisk or dry cloth. Do not use
any liquids for cleaning.
• Clean the oil passages of the chain
bar ( 26), in order to guarantee a
trouble-free, automatic oiling of the
saw chain during operation.
8) so that this area
A
A
GB
4).
47