Assembly; Mounting The Saw Chain And Blade; Tensioning The Saw Chain - Deltafox DG-ECS 2240 Traducción Del Manual De Instrucciones Origina

Assembly

Always wear protective gloves
when working with the chainsaw
and employ only original parts.
Pull out the power plug before
doing any work on the chainsaw
itself -– injury hazard!
Before putting the electric chain saw into
operation, you must:
- install the blade, saw chain and chain
cover where necessary,
- adjust the saw chain tension,
- pour in chain oil,
- check the function of the chain brake
and the automatic oil pump.
Mounting the saw chain
and blade
1. Lay the saw on a flat surface.
2. Turn the fastening bolt (7) anti-clock-
wise ( ) to remove the sprocket
chain wheel covering (8).
3. Spread the chain (5) out into a loop
with the cutting edges running clock-
wise .
4. Slide the saw chain (5) into the bar
guide groove. To mount the guide bar
(4), raise it to an angle of approx. 45
degrees. This will make it easier to
replace the saw chain (5) onto the
sprocket (24).
5. Place the chain bar (4) and saw chain
(5) on the bar bolts (23). When the
nose on the right below the bar bolt
(23) sits in the round recess on the
blade, the blade is placed correctly. It
is normal for the saw chain (5) to sag.
It is normal that the saw chain (5) is
slack.
6. Pre-tension the saw chain (5) by
turning the screw for the chain quick-
tensioning system (9) in clockwise
direction.
7. Position the sprocket chain wheel cov-
ering (8). First place the tab (25) on
the cover into the corresponding notch
on the plate (8). Tighten the fastening
bolt (7).
Note that the saw can re-oil.
Please note that the saw re-oils after
use and oil may leak out if it is stored on
its side or on the head. This is a normal
process due to the necessary ventila-
tion opening on the upper edge of the
tank and does not constitute a reason for
complaint. As each saw is checked dur-
ing production and tested with oil, a small
residue may be in the tank despite drain-
ing, which may slightly dirty the housing
with oil in transit. Please clean the hous-
ing with a cloth.
Prior to changing the chain, the nut of the
guide rail must be cleaned of dirt because
dirt deposits available can cause the
chain to break out of the rail. The depos-
its can also absorb the chain oil. So the
consequence would be that the chain oil
would not or only a small part of it would
reach the underside of the rail and the lu-
brication would be reduced.

Tensioning the saw chain

Regularly tightening the saw chain pro-
vides safety for the user and reduces and/
or prevents wear and chain damages.
Before the start of work and in approx. 10
minute intervals, we recommend the user
to examine the chain tension and correct
it, if necessary.
The chain warms up when working with
the saw and thus expands slightly. These
GB
41