Terraillon USB DESIGN Manual De Instrucciones página 5

TERRAILLON ELECTRONIC BATHROOM SCALE
Dear Customer;
Thank you for purchasing this product. Please read
these instructions carefully to take full advantage of your
product.
READ BEFORE USE
• Do not disassemble the scale as incorrect handling may
cause injury.
• This product is not intended for professional or medical
use; it is intended for private use only.
• Clean with a lightly dampened cloth without allowing
any water to get into the device. Do not use solvents or
immerse the product in water.
• Avoid excessive impact or vibration to the unit, such as
dropping the product onto the floor.
• Important: if the appliance is moved before weighing
or between two weighing sessions, reinitialize the
scale (See «Initialisation'').
• The scales switch off after approximately 15 seconds
of inactivity. Once the display has disappeared, wait 10
seconds before stepping back onto the scales. (Renew
this operation between each weight measurement).
• USB Design contains a 3.7 V/300 mAh lithium battery.
PRODUCT USAGE
Before first use, the scales must be charged for at least
one hour before they can be switched on for the first time.
Charging
• Make sure that the ON / OFF push button located on the
side of the scale is pressed (ON position).
• To charge the scales, plug the supplied cable (to be used
with a USB charger, not supplied) into the connector on
the side of your scales. The following displays will appear:
• Once the battery is fully charged (after approximately
2 hours), the following display will appear:
• Once charging is complete, unplug the charger. Leaving
the product charging for too long is not recommended
as this may damage the battery.
EN
Initialising
• For the scale to work, the ON / OFF push button on the side
of your scale must be pressed (ON).
• The scales must be initialised the first time they are used, each
time they are moved, and after they have been charged. Press
briefly and sharply with your foot in the middle of the platform.
The display reads « 0.0 » then the scale automatically turns off.
Your scale is now is now ready for use.
Measurement unit
1. Press and hold (for approximately 3 seconds) the "UNIT"
button on the back of the scales to activate the unit
selection mode. The unit that is currently activated will
flash.
2. To select the desired unit (kg, lb or st), briefly press the
"UNIT" button as many times as necessary until the
desired unit flashes.
3. Then press and hold again to confirm your choice. The
unit will stop flashing.
Operation
kg
Warning indicators
The scales say «Hi!» to you when they are switched on.
Overload: remove weight immediately.
Battery low, charge scales.
Error, down and back up on the scale.
PROTECT THE ENVIRONMENT
After life, dispose of this product at a designated
waste recycling point.
GUARANTEE
This product is guaranteed against defects in materials
or manufacturing. During the guarantee period, any such
defects will be repaired free of charge (proof of purchase
must be shown in the case of a complaint under guarantee).
The guarantee does not cover damage resulting from
improper use or negligence. In the event of a claim, first
contact the shop where you purchased the product.
Autostop
3
kg
5