Mounting/Removing The Grass Box; Adjusting The Cut Height; Switching On And Off - Grizzly Tools ARM 4038 Lion Set Traducción Del Manual De Instrucciones Original

correctly. Ensure that the coll-
ection bag is installed correctly
and the device has been moun-
ted properly. Do not use the
device if a switch is damaged.
Personal protective equipment
and a fully functional appliance
reduce the risk of injuries and
accidents.
Adjustments on the mower, as
well as assembly and disas-
sembly of the collection basket,
mulch kit and lateral ejection
chute, etc. may only be made
while the motor is switched off
and the blades are at a stand-
still.
Switch of the device, pull the con-
tact chip (
blades to come to a stop. There is
a risk of personal injury.
Observe noise control and local
regulations.
Mounting/removing the
grass box
1. To mount the grass catch box (13) lift
the impact protection (14) and mount
the grass catcher box (13).
2. Lower the collision guard (14) onto the
grass box (13) - it will keep it in place.
3. To remove the grass box (13), lift the
collision guard (14) and unhook the
grass box from the mounting bracket.
Flap down the collision guard to the
housing.
A level indicator is fitted on the
side of the grass bag.
17) and wait for the
Flap open:
grass catcher empty
Flap closed:
grass catcher full

Adjusting the Cut Height

There are 5 different cutting heights:
60 - 75 mm - large cutting height
40 - 60 mm - medium cutting height
25 - 40 mm - low cutting height
1. Hold the cutting height adjuster
(8) and move it to the correct
cutting height, as appropriate.
The correct height is around 25 – 45 mm
for a decorative lawn and around
45 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the
season.
Observe noise control and local
regulations.

Switching On and Off

1. Place the mower on a level sur-
face.
2. Lift the battery cover (6) of the
device housing and insert the
charged battery (7) along the
guide rail into the device. It
clicks audibly into place.
3. Insert the contact chip into the
opening provided on the power
switch (17).
4. Before switching on, ensure
that the equipment is not in
contact with any objects.
GB
27