To Replace A Damaged Starter Rope - Husqvarna K 1270 II Manual Del Usuario

To replace a damaged starter rope

1. Pull out the starter rope approximately 30 cm (A).
A
2. Hold the starter rope pulley (B) with your thumb.
3. Put the starter rope in the notch (C) in the starter
pulley .
4. Put the starter rope around the metal sleeve.
5. Let the starter pulley rotate slowly and the starter
rope wind up on the metal sleeve.
6. Pull the starter rope to release it from the metal
sleeve.
1631 - 001 - 04.05.2021
C
B
7. Remove the cover on the starter rope handle (A).
A
8. Pull the starter rope up through the handle (B).
9. Release the knot (C).
10. Remove the starter rope.
11. Make sure that the recoil spring is clean and not
damaged.
12. Put a new starter rope (A) in the hole in the starter
housing.
A
B
C
33