Electrical Requirements - LiftMaster MERIK SECURITY+ 790LMK Manual Del Propietário

INSTALLATION STEP 9

Electrical Requirements

To avoid installation difficulties, do not run the opener at
this time.
To reduce the risk of electric shock, your garage door opener has
a grounding type plug with a third grounding pin. This plug will
only fi t into a grounding type outlet. If the plug doesn't fi t into the
outlet you have, contact a qualifi ed electrician to install the proper
outlet.
RIGHT RIGHT
If permanent wiring is required by your local code, refer to the
following procedure.
To make a permanent connection through the 22 mm diameter
hole in the top of the motor unit:
• Remove the motor unit cover screws and set the cover aside.
• Remove the attached 3-prong cord.
• Connect the black (line) wire to the screw on the brass terminal;
the white (neutral) wire to the screw on the silver terminal; and
the ground wire to the green ground screw. The opener must
be grounded.
• Reinstall the cover.
To avoid installation difficulties, do not run the opener at this
time.
WRONG WRONG
To prevent possible SERIOUS INJURY or DEATH from
electrocution or fi re:
• Be sure power is NOT connected to the opener, and
disconnect power to circuit BEFORE removing cover to
establish permanent wiring connection.
• Garage door installation and wiring MUST be in compliance
with ALL local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change
plug in ANY way to make it fi t outlet. Be sure the opener is
grounded.
PERMANENT WIRING PERMANENT WIRING
CONNECTION
CONNECTION
Ground Tab
Ground Tab
Green
Green
Ground Screw
Ground Screw
Ground Wire Ground Wire
24
Black Black
Wire Wire
Black Wire
White Wire Black Wire
White Wire