Start Up Instructions; List Of Materials; Mounting The Machine; Overload Protection - Garland Comber 141 E Manual De Instrucciones

English

5. START UP INSTRUCTIONS

5.1. LIST OF MATERIALS

This machine includes the following elements that you
will find inside the box:
• Engine
• Tube connecting screw
• Connecting wing nut
• Instruction manual

5.2. MOUNTING THE MACHINE

1. Introduce the superior tube into the inferior tube
and connect using the screw and wing nut
provided.
2. Place the handle in the most comfortable working
position.
5.3. CHECKING POINTS PRIOR TO WORKING
The current and tension supplied must coincide
with those in the characteristics label. Prior
to starting work check that the machine works
adequately and all security measures work.
Check the machine and look for any loose pieces
(screws, nuts, housing etc) and for any damages.
Tighten, repair or replace those pieces that you have
found to be in a bad state. Ensure that there are no
leakages. Do not use the machine if damaged or not
well regulated.
5.3.1. CABLE FIXATION
Only use cable extensions that are homologated
for outdoor use. The cable section must be at least
1.5mm and the cable extension should never be
longer than 25m and must be completely unrolled
All manuals and user guides at all-guides.com
before starting to work.
Fix the extension of the
tiller by inserting cable in
the hook on the handle and
plug onto the machine.
5.4. START UP AND STOPPAGE
Start up the machine:
Press the security button (1)
and without letting go, press
the On/Off switch (2).
Stoppage of the machine:
Let go of the On/Off switch (2).

5.5. OVERLOAD PROTECTION

This machine has a security switch that will
disconnect the machine If the machine detects a
high level of resistance on the blades.
If you detect that the machine does not start when the
switch is on the On position, the probable cause will
be that the security switch is activated. In this case
disconnect the machine from the mains, place the
switch on the Off position, check that the blades are
clean and have no elements that impede the blades
from turning and wait 15 minutes before starting the
machine again.

6. MACHINE USAGE

Use this machine only for those purposes for which it
has been designed. The usage of this machine for any
other purposes is dangerous and can cause damages
to the user and the machine.
8/64
1
2