Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
5. START UP INSTRUCTIONS
5.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Engine
• Tube connecting screw
• Connecting wing nut
• Drums
• Battery charger
• Instruction manual
5.2. MOUNTING THE MACHINE
1. Introduce the superior tube into the inferior tube
and connect using the screw and wing nut
provided.
2. Place the handle in the most comfortable working
position.
3. Install the lithium battery, before installing the
battery, make sure the switch is off.
Install the battery by sliding it along the rails
until it is connected securely in the
machine
To remove the battery, press the pneumatic button
on the battery
5.3. CHECKING POINTS PRIOR TO WORKING
The current and tension supplied must coincide
with those in the characteristics label. Prior
to starting work check that the machine works
adequately and all security measures work.
Check the machine and look for any loose pieces
(screws, nuts, housing etc) and for any damages.
Tighten, repair or replace those pieces that you have
found to be in a bad state. Ensure that there are no
leakages. Do not use the machine if damaged or not
well regulated.
5.4. START UP AND STOPPAGE
Start up the machine:
Press the security button (1)
and without letting go, press
the On/Off switch (2).
Stoppage of the machine:
Let go of the On/Off switch
(2).
5.5 BATTERY CHARGING
The supply voltage and current must comply with the
information on the rating plate of the charger.
To charge the battery plug the charger into the
network. Place the battery in the charger, the led will
light red. The led will change from red to green when
the battery is fully charged.
When the battery is charged, remove it from the
charger. If you insert the battery in the charger and
the LED starts flashing red, it means that your battery
is damaged or that the battery does not correspond to
this charger.
26/80
1
2
Publicidad
Capítulos
Tabla de contenido
