Scene Mode - Lutron Grafik Eye QS Guía Rápida De Instalación Y Funcionamiento

Occupancy Sensor Setup

Scene Mode

This step allows you to assign occupied and unoccupied scenes to up to four
occupancy sensors connected to the GRAFIK Eye
Select Sensors
Occ Sensor
1. If not already done, select "Scene Mode" from the
Setup
Occupancy Sensor Setup menu.
2. Use the Master buttons to highlight "Setup" and press the
Labels
OK button to accept. The screen will display "Searching" while
the unit detects available occupancy sensors.
3. Use the Master buttons to scroll through the list of available
occupancy sensors. When the desired sensor is displayed,
Saved
Searching
press the OK button to select it. Then choose "Assign" or
"Unassign" from the following menu and press OK. A screen
will verify your choice has been completed. Repeat for
additional sensors.
Sensor x/y
Set Sensor Action
4. Press the Back button to return to the Occ Sensor screen.
SN: xxxx-xxxx
Use the Master buttons to highlight "Actions" and press the
Source: RF 1/n
OK button to accept. By default, the occupied scene is set to
"No Action" and the unoccupied scene is set to "Scene Off".
5. Use the Master buttons to highlight the scene you wish to
Assignment
use for occupied status and press the OK button to accept.
Repeat for the scene you wish to use for unoccupied status.
Assign
Press the OK button to accept.
Unassign
6. Exit programming mode (see page 9).
Note: If wireless sensors are not found, verify that they are
Saved
*Assigned*
Occ Sensor
Actions
3 seconds
Setup
®
1 9
QS control unit.
®
associated correctly (see page 14).
Occupied Scene
Scene 1
For additional information, see the complete installation and operation guide at www.lutron.com/qs
2 10 3 11 4 12 5 13 6 14 7
Unoccupied Scene
Scene Off
GRAFIK Eye QS with DALI Quick Installation and Operation Guide 15
®
15 8 16
9-16
1-8
OK
Saved
Saved
Master
buttons
OK
button
Timeclock
(back) button