Lutron Grafik Eye QS Guía Rápida De Instalación Y Funcionamiento página 21

Scene Setup
Set Zone Levels, Fade Rates, and Window Treatment Group Actions
1. Enter programming mode (see page 9).
Main menu
2. Use the Master buttons to highlight "Scene setup" and press
Timeclock
the OK button to accept.
Scene setup
3. Use the Master buttons to highlight "Levels" to adjust lighting
and/or window treatment levels. Press the OK button to
accept. Use the Master buttons to highlight the scene number
Scene setup
of your desired scene. Press the OK button to accept.
Levels
4. Set each zone to the desired light level for this scene using
Labels
the zone raise/lower buttons. The info screen will display the
zone and percentage as you adjust it.
To set a zone as unaffected, lower the light levels all the way
Scene setup
to off, then hold the zone lower button for 3 seconds. The
screen will display "---" and the three middle LEDs for the
zone will be lit to indicate this zone is unaffected by the scene
Scene 1
(the zone will not change when this scene is initiated).
When all zones are at the desired level, press the OK button to
accept.
Scene 1
5. Use the Master buttons to set the fade time for this scene.
Set zones
Press the OK button to accept.
6. Note: This step is applicable only if you have window
3 seconds
treatments on your system. If you do not have or do not wish
to set window treatment groups for this scene, press the OK
Scene 1 button to skip this step.
Press the shade button that will take the window treatments
Adjust fade
assigned to that button group to the level you want for this
3 seconds
scene. Repeat for any additional shade button groups. Press
the OK button to accept. For window treatment programming,
see the complete installation and operation guide at www.
Scene 1
lutron.com/qs.
7. The info screen will confirm that your scene has been saved.
Set shade
Groups
8. Exit programming mode (see page 9).
Saved
®
3
1 9 2 10 11 4 12
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
5
13 6 14 7 15 8 16
9-16
1-8
1 9 2 10
1 9 2 10
QS with DALI Quick Installation and Operation Guide 21
®
Master
buttons
OK
OK
button
Timeclock
(back) button
3 11 4 12 5 13 6 14 7 15 8
Shade
button group
3 11 4 12 5 13
Zone raise
Zone lower
16
1
6 14