Setup Instructions - Kathrein UFO UFO 394 Manual Del Usuario

2. Setup instructions

The QPSK-PAL UFO 394 twin transponder is set up via the central controller for the UFG 3xx base unit.
The following instructions apply generally:
To view the software versions of the boot loader, controller and channel unit, press the three "<<", ">>" and "?" buttons
simultaneously
Select a desired parameter using the cursor buttons "→" or "←"
The selected parameter will fl ash
To move to another editable parameter, press the Up-/Down-Scroll buttons ("+"/"-")
When inputting the satellite frequency and the symbol rate, it is easiest to input each decimal point separately.
To do this, fi rst select the respective parameter using the cursor buttons "→" or "←", then press the cursor buttons "→" and
"←" simultaneously. Now the desired position of the decimal point can be activated using one of the cursor buttons.
The scroll button can be used to move the respective position of the decimal point.
Normal operating mode can be resumed by once again pressing the cursor buttons "→" and "←"
For a more detailed explanation of the selected parameter, press the "?" button
New channel unit data should be saved by pressing the red "Save" button only once the module
has successfully completed its acquisition procedure and the TV channels found are shown in the display.
If the settings are changed but not saved, after about 10 minutes the channel unit will revert to its original parameters.
From pressing the Memory button "M", the time to perform the save is approx. 3 seconds.
2.1 Selecting the signal input and the twin unit
1236 MHz
I
TV Das Erste
Outp. CH12 244.25MHz
Auto Vol -3dB
*** UFO 394-I
A
Input
DiSEqC-B off
2.2 Selecting input frequency
I 1236 MHz
1236 MHz
TV Das Erste
Outp. CH12 244.25MHz
Auto Vol 0
*** UFO 394-I
SNR 11dB
BER 1.0E-0.6
All manuals and user guides at all-guides.com
Select the parameter "Twin unit".
27.5 MS
Switch over to displaying the desired twin unit with "<<" or ">>".
deu
Press the " " button to call up the sub-menu with:
The type designation of the module including display of the twin unit that
the controller is addressing
***
Display of the "A/B" input being used by the two twin units I and II – use
the scroll buttons to change over between A and B
Selection of the DiSEqC™ signal to be sent via the HF "B" socket
Press the " " sub-menu key to return to the main menu.
Select the parameter "Input frequency" and set it between 950-2150 MHz in
27.5 MS
1-MHz steps (using the scroll button or by inputting the fi gures)
deu
Press the " " button to call up the sub-menu with:
The type designation of the module
*** The Signal-to-Noise ratio (SNR) and the Code Rate for the received
signal determined by the unit
CR 3/4
The Bit Error Rate (BER) associated with the SNR
Press the " " sub-menu key to return to the main menu.