Drip-Stop Function; Automatic Switch-Off; Cleaning; Self-Cleaning Function - Silvercrest SDB 2200 C1 Instrucciones De Uso

Drip-stop function

With conventional steam irons it can occur that water
drips from the ironing sole q at low temperatures.
However, this iron possesses a new equipment cha-
racteristic, the DRIP-STOP function. At low tempera-
tures the iron automatically switches off the steam-
blast function. When this happens, a "CLICK" is
heard. You must then select a suitable temperature
using the thermostat 8. As soon as this is reached,
steam production continues.

Automatic switch-off

The iron is equipped with an automatic switch-off.
This stops the iron from heating up.
If the iron is standing on its ironing sole q and has
not been moved for approx. 30 seconds, acoustic
warning signals are heard and the automatic switch-
off indicator lamp 6 flashes. The iron will no longer
be heated. To deactivate the automatic switch-off,
pick up the iron and move it around a little. The
automatic switch-off indicator lamp 6 will go off
and the iron will heat up again.
If the iron is standing on its base 0 and has not
been moved for approx. 8 minutes, acoustic warning
signals are heard and the automatic switch-off indi-
cator lamp 6 flashes. The iron is no longer heated.
To deactivate the automatic switch-off, pick up the
iron and move it around a little. The automatic
switch-off indicator lamp 6 will go off and the iron
will heat up again.
Note:
The automatic switch-off is not a substitute for un-
plugging the apparatus from the power supply! It is
only intended for reducing the risk of fire if the iron
is accidentally left on!
All manuals and user guides at all-guides.com

Cleaning

Self-cleaning function

• Fill the water tank to the MAX marking.
• Insert the plug into a wall socket.
• Move the thermostat 8 to the MAX position.
• Adjust the steam regulator 3 to maximum steam
power.
• Allow the steam iron to heat up until the tempera-
ture control lamp 7 switches off and once
again glows.
• Hold the steam iron horizontally over a catchment
receptacle.
• Position the steam regulator 3 at the maximum
steam power level. Press and hold down the
self-clean button w. Thereby, steam and boiling
water flows from the steam exit holes in the ironing
sole q. Impurities that may be present are was-
hed out.
• Release the self-clean button w as soon as all
of the water has exited.
• Thoroughly dry the ironing sole q. For this, slide
the ironing sole q back and forth over a hand
towel or an old piece of material several times.
• Allow the steam iron to cool down before placing
it in storage.
- 38 -