Cosatto TO & FRO NITTY GRITTY Manual Del Usuario página 5

All manuals and user guides at all-guides.com
9 - fitting the softgoods - parent facing mode
Note: Before fitting the footmuff check that the support wedge is fitted (a).
Remove the chest pads by releasing the fabric fastener along the length of the chest pad (b).
Unfasten the harness and unclip the shoulder straps from the waist strap clips by pressing the
sprung arm (c) on the shoulder strap clip and unhooking the clip from the waist strap clip (d).
Pass the harness straps through the slots in the footmuff and seat liner (e, f & g) then attach the
fasteners to the back of the seat (h).
Fit the headhugger, ensuring that the shoulder straps fit above the headhugger slots (i).
Refit the chest pads to the shoulder straps.
Removing the footmuff and headhugger is the reverse of this.
Note: Please note the seat liner, fitted with the support wedge, must be used in parent facing mode.
10 - using the back support - parent facing mode
In parent facing mode, there are 3 back support positions. The most reclined position in parent
facing mode is recommended for new born babies until ready to progress to more upright
position. (e.g. this may be when they can sit up unaided.)
Before adjusting the back support release the seat retaining flap at the rear of the backrest (a).
Press the buttons on both sides of the back support (b) and adjust the angle of the back support (c).
Release buttons (d) to lock the back support in position.
When the back support is in the desired position refasten the seat retaining flap to complete the
process.
11 - using the basket - parent facing mode
Zip fasteners (a) on each side of the basket allow access to the basket when in parent facing mode.
12 - fitting the hood - parent facing mode - 1
The supplied hood can be used for both parent and forward facing modes. The hood is pre-set for
fitting in parent facing mode.
Noting the arrow on hood mount indicating the correcting alignment of the hood. In parent
facing mode the arrows should point towards the hood (a).
Slide the hood mounts on to the fixing brackets on either side chassis (b).
13 - fitting the hood - parent facing mode - 2
Open the hood fully (a).
Fit the back of the hood over the headrest (b).
Fasten the clip under the backrest (c).
Ensure the fastening strips of the each side of the hood are fastened (d).
To retract the sunvisor push it down & back into the hood (e). To extend is the reverse of this (f).
To lower the hood push back on the front top section (g).
Removing the hood is a reversal of steps 12 & 13.
14 - folding the chassis - parent facing mode
Note: If the hood is fitted, retract the hood completely before folding (a).
Raise the backrest (b).
To fold the chassis pull up the handle (c) and at the same time press down on the secondary lock (d).
Keeping the secondary lock pressed down, push the handles forward until the chassis is folded in
half. Continue pushing until the autocatch engages.
Note: Take care not to damage the stand mechanism when folding. Pressing
down too hard on the chassis can bend the stand arms (e).