Cosatto TO & FRO NITTY GRITTY Manual Del Usuario página 6

All manuals and user guides at all-guides.com
15 - converting from parent facing mode to forward facing mode - 1
Remove the chest pads, footmuff and headhugger (A reversal of the procedure in Step 9) and
attach the harness.
Remove the head pad (a).
Remove the support wedge (b) from footmuff.
Reverse the hood by gripping the material at the base of the back of the hood and pull it up and
over the top (c & d) until the inside of the hood has become the outside and the hood now faces
in the opposite direction (e). The arrows on the hood mounts should now point away from the hood (f).
16 - converting from parent facing mode to forward facing mode - 2
Lift the lever (a) on the seat back and lift the seat upright (b).
Pull the seat retaining flap away from the underside of the calf support (c).
Lift the seat up until it swings up to the backrest (d).
Fasten the seat retaining flap to the rear of the backrest (e).
17 - fitting the softgoods - forward facing mode
WARNING: Do not use head pad & footmuff wedge in forward
facing mode.
Unfasten the harness and remove the shoulder straps clips from the waist strap clips (a).
Pass the harness straps through the slots in the footmuff and seat liner (b, c & d) then attach the
fasteners to the back of the seat (e).
Fit the headhugger, ensuring that the shoulder straps fit above the headhugger slots (f).
Refit the shoulder straps clips to the waist strap clips.
Refit the chest pads to the shoulder straps (g).
Removing the footmuff and headhugger is a reversal of this procedure.
18 - fitting the hood - forward facing mode - 1
Before fitting check the hood is set for forward facing mode (See Step 15).
Noting the arrow on hood mount indicating the correcting alignment of the hood. In forward
facing mode the arrows should point away from the hood (a).
Slide the hood mounts on to the fixing brackets on either side chassis (b).
Fit the back of the hood over and behind the backrest (c).
19 - fitting the hood - forward facing mode - 2
Raise the hood by pulling top front section forwards (a).
Fasten the fabric fastener around the front leg tubing (b)
Fasten the clip behind the backrest (c).
To lower the hood push back on the front top section (d).
There is a flap on the rear of the hood. Lift the flap to view inside the pushchair (e). Lower the flap
to close.
There is a pocket on the rear of the hood. Lift the flap (f) to gain access to the pocket. Maximum
weigh in hood pocket 0.2kg.
To extend the sunvisor pull the sunvisor forward from the hood (g). To retract is the reverse of this
procedure (h).
20 - positioning the backrest
The backrest can be adjusted. To lower, simply lift the lever behind the backrest (a) and release the
lever at desired position. To raise the backrest is a reversal of this procedure.