Wide Panel - Sigma EF-530 DG SUPER Manual De Instrucciones

ATTACHING AND REMOVING THE FLASH TO AND FROM THE CAMERA
Be sure turn off the Power Switch. Then insert the Shoe Base
into the hot shoe of the camera until it clicks and locks. ①
◆ When you attach or remove the flash, grasp the
bottom of the flash to prevent damage to the shoe foot
and camera's hot shoe.
◆ If the camera's built-in flash is set in up position,
please close it before you attach the flash unit.
When you remove the flash, slide the flash unit out of the
camera's hot shoe, while pressing the release button. ②
SETTING OF FLASH COVERAGE ANGLE
When you press the ZOOM button
panel display will change and indicate the zoom position in sequence, as follows.
24mm → 28mm → 35mm → 50mm → 70mm → 85mm → 105mm →
Generally, in the TTL mode, the flash will automatically set the zoom position according to the focal length of your lens.
◆ When you turn on the main switch, the flash will memorize and set the zoom head position to the last setting used.
◆ If you use a lens wider than the flash head setting, there may be under exposed areas around the edge of the picture.
◆ Depending on the flash head setting, the flash's Guide Number will be changed.

WIDE PANEL

This flash is equipped with built in type wide panel, which can
provide ultra wide 17mm angle of coverage. Slide out the wide
panel and flip it down to cover flash's head. Then the coverage
angle setting of the flash will be set to 17mm automatically.
◆ If the built-in wide panel comes off accidentally, the
button will not function. In this case please contact the store
where you have purchased the flash, or a service station.
LCD PANEL ILLUMINATION
When you press the
LIGHT
on longer than 8sec, if you press the
TTL AUTO FLASH
In the TTL AUTO Mode, the camera will control the amount of flash lighting, to get the appropriate exposure
for the subject.
◆ Depending on the camera model and lens combination, TTL Flash procedure varies. Please see the
below chart. (In all combinations, TTL will be displayed on the LCD)
D-SLR / Maxxum 70, 50, 7, 5, 4, 3
Dynax 7D, 60, 40, 7, 5, 4, 3L
D type Lens ADI metering
Non-D type lens Pre-flash metering
◆ Depending on the Camera or Exposure mode, this equipment will choose fill flash or auto flash. When fill
flash is chosen will blink on the LCD panel of flash.
4. Set the camera's exposure mode to P Mode.
5. Turn on the power switch of the flash, the TTL mark will appear on
the LCD panel and the flash will start charging.
◆ With D-SLRs, please make sure that
indicator is off, press the + or – button and make the indicate
indicator appear on the LCD panel, otherwise exposure will not
be correct.
All manuals and user guides at all-guides.com
symbol appears. Each time you press the ZOOM button, the LCD
ZOOM
button, the LCD panel will illuminate for about 8 seconds. The illumination stays
button once again.
LIGHT
indicator is on. If the
Maxxum 9
Dynax 9
Pre-flash metering
Pre-flash metering
( Auto)
Other Camera Models
Ordinary TTL metering
Ordinary TTL metering
14