Package Contents - Bodypoint Monoflex SH120 Instrucciones De Instalacion Y De Uso

PACKAGE CONTENTS

1 or 2 piece Monoflex™
Mounting straps with Cinch-mount™ or Flat-
mount™, or Mounting straps with grommets
Cinch-Mount™ Flat-Mount™
DIRECT SCREW MOUNTING
Mounting straps can be attached directly to solid back surfaces. Use 6mm (1/4") Flat head or Button
head screws to mount to chair frame or solid back. Mounting screws must have a minimum pullout
strength of 90kg (200lbs). (Not included in package.)
BELT MOUNTING HARDWARE
Mounting straps can be attached using any type of
Bodypoint belt mounting hardware with 6mm screws.
(HW320 Band Clamps shown, for other types see
www.bodypoint.com/hardware.aspx)
ADJUSTMENT
With the user correctly seated, check the fit of the belt – it
should be snug so the user is secure. Small adjustments in
fit are done using the D-ring tightening straps. Large adjust-
ments in fit are done using the mounting straps.
POSITIONING
Seat user in wheelchair and establish correct
posture with pelvic support belt. Determine
desired position for the chest belt.
Position lower over the belly for more freedom
of movement – position higher over the chest
for more trunk control. When choosing position,
consider interference with other devices.
SAFETY CHECK
When properly positioned in wheelchair,
have user lean forward and side to side to
check fit. Check for:
1. Normal operation of buckles and
adjustment straps.
2. Comfort – If any rubbing occurs
relocate straps.
3. Position - If too high or too low, adjust
mounting location.
4. Interference with other devices – Relo-
cate straps as necessary to clear arm-
rests, accessory pads, or feeding tubes.
en