11. Do not pack the cabinet with foods. Allow
some space between them to ensure a good
air flow.
12. Do not put in warm or hot foods. Let them
cool first, or they will raise the cabinet
temperature and could deteriorate other
f o o d s i n t h e c a b i n e t o r o v e r l o a d t h e
refrigerator/freezer.
13. Make sure all items are snug on each shelf.
14. Moist or fresh foods and those with a strong
smell like seafood should be wrapped up
in a plastic film or packed in a container.
Otherwise the foods may dry up or give their
smells to other foods.
15. Foods containing acetic acid or yeast should
be wrapped up in a plastic film. Otherwise
t h e y m a y a c c e l e r a t e c o r r o s i o n o f t h e
evaporator and copper tubes, resulting in
failure.
16. F o o d s i n t e n d e d f o r d i r e c t h u m a n
consumption should be stored on the shelf in
a proper container and protected from direct
contact with the cabinet walls.
17. Do not use the freezer to freeze foods. It is
designed only to store frozen foods. High
quality ice cream may melt during defrost
cycle and should not be stored in the freezer.
18. The doors may become difficult to open
just after closed because of the negative
pressure created inside the cabinet. Wait for
about 30 seconds.
[a] START UP
1) Plug in the unit.
2) The compressor and condenser fan motor will
start in 3 minutes.
[b] FRONT PANEL
To open and close the front panel:
Pull each side of the front panel toward you to
release it from the holder on each side of the bottom,
and swing up the front panel as shown.
To close the front panel, fit both sides of the bottom
securely in the holders.
Holder
To hold the front panel open:
Hook the front panel securely on both sides of the
top as shown. It may be unhooked when pulled up in
the direction of arrow 1.
To unhook the front panel, lift up both sides of the
front (arrow 1) and push in the direction of arrow 2.
Front Panel
Securely
To remove the front panel:
Release both sides of the bottom from the holders,
and lift it off vertically.
Holder
[c] CABINET TEMPERATURE SETTING
The cabinet temperature is factory-adjusted to
3°C for the refrigerator and -18°C for the freezer. If
necessary, readjust the temperature as follows:
1) Open the front panel.
5
ENGLISH
Front Panel
Fig. 5
Front Panel
Fig. 6
Front Panel
Fig. 7